Outside the raincoat package, there will be a comparison table for selecting the size of the raincoat based on the height. However, because the raincoats manufactured by the raincoat manufacturers on the market have different sizes, it is not recommended that consumers directly purchase different raincoats according to the size of the raincoat. Brand of raincoat, prone to errors. It is best to try on raincoats, but usually raincoats in shopping malls cannot be tried on. It is recommended that people with size M should wear raincoats of size L. By analogy, the protection will be better, even if you wear more clothes in winter. Raincoat maintenance Note that the maintenance part of the water repellent layer is mainly raincoats made of nylon and polyvinyl chloride. The surface of the new raincoat has a water-repellent coating, which allows rainwater to form droplets on the raincoat and shorten the drying time. In order to protect the water-repellent coating, it can only be wiped and dried, or rinsed with water. However, after more than ten times of use, the water-repellent coating will naturally fall off due to rain erosion. At this time, it can be maintained in other ways. After using the raincoat, it is best to wipe it with a dry cloth and dry it naturally in a cool place, not in the hot sun. Do not rub when washing raincoats, as this will detach the PVC and nylon fabrics, allowing air to penetrate and foam.
Rubber raincoat storage method When storing rubber raincoats, newspapers can be lined in the interlayer, or sprinkled with a layer of prickly heat powder and then folded, so that they will not stick after a long storage time. The plastic raincoat wrinkle removal method has slight wrinkles on the raincoat, you can hang it on the hanger and let it flatten naturally. If the wrinkles are tight, you can soak the raincoat in hot water of about 70 degrees Celsius for two minutes, take it out and put it on a flat plate to flatten it, and then wipe off the water marks, and it can be restored to a flat shape. Be careful not to pull it hard. Plastic raincoat adhesive repair method If the plastic raincoat is broken, you can align the break first, put a piece of cellophane on it, and then press it with a hot iron bar a few times. The time of pressing each time should not be too long, so that the cellophane will not be scalded. , and the plastic underneath is glued. For holes, you can use the same plastic cloth to cut into squares or circles slightly larger than the holes, cover the holes, then cover with cellophane, and use the same method to heat and glue them. Rubber raincoat odor removal method When the rubber raincoat has an odor, you can mix hydrogen peroxide into the water to soak the raincoat, and the odor will disappear after drying.
